Now on the very bottom right you’ll see three buttons click on the top button to open the write speed settings page. Now on the right hand side click on the “Device” tab To set the write/burn speed you have two options…ġ.) Set the same preferred burn speed for all drives by clicking on “Tools” and select “Automatic write speed”Ģ.) Set different burn speed for each drive by placing a blank disc into the drive/burner, with ImgBurn open make sure your drive is selected in the target window…(lower left side) If you wish to use the verify feature thenon the write tab in ImgBurn’s settings make sure the verify check box is selected located on page #1 Open ImgBurn and click on “Tools” located on the menu bar and select “Settings”Ĭlick on the “Build” tab and on page #2 make sure there is a check mark in the following boxes…
Now click OK to save changes and close DVDFab
Note…If you wish to use the verify feature make sure the feature is not selected within DVDFab’s common settings-> “Write” Open DVDFab and go into common settings by clicking on the “Check mark” icon in the upper right corner of the title barĪnd click on “Write” located on the left side to open the write settings page and select ImgBurn as the burn engine, you will want to select “Recommended” as the write speed to avoid any conflicts on the burn speeds between DVDFab and and ImgBurn.
ImgBurn must be installed on your system before using this guide, if you don’t have ImgBurn download by clicking this Link.